Skyline 32 Flight Controller + on board OSD to simplify your
FPV build. No need for unreliable external OSD modules anymore. With a simple
flick of a switch, the OSD can easily and quickly be turned ON or OFF. The OSD
is integrated into the Flight Controller so setting up is simple.
Connect an fpv camera and Video Tx directly to the Skyline
32 + OSD board. With MW_OSD pre installed on the Skyline32+OSD, the pilot can
change PID on the spot through OSD without having to connect to a computer.
Simply use the transmitter’s stick commands and follow the OSD menu. Supports
PPM signal via Channel 1 in RC_IN port (UART2), and supports SBUS signal via
Channel 4 in RC_IN port (UART2).
Run Cleanflight, Betaflight, or Baseflight
Wire-to-Board micro connectors.
Built-in gyro/accelerometer, magnetometer (Advanced Version
also includes barometer and magnetometer)
Blackbox ready with 2MB of storable data.
Thin and ultra compact for clean/tight builds.
Uses top quality electronic components and high precision
32-bit ARM micro processor running at 3.3v / 72MHz.
Fly in Manual Mode, Angle Mode, Horizon Mode, Head-Holding
Mode, Head-free Mode, and Altitude-Hold Mode (Altitude-Hold Mode is available
in Advanced version).
Supports Quad-,Tri-,Hex, Octo-, various multirotors.
Flexible RC Input: PPM, Non-Inverted SBUS, PWM.
Flash to latest firmware through the Micro-USB (**NOTE:
Please be sure to leave OSD switch OFF when using Micro-USB).
GPS Hold / Return-To-Home Feature supported (GPS module
Dimension: 35mm x 35 mm x 5 mm (30.5mm Mounting)
Weight: 4.8g (W/O wires)
1x SKYLINE32+OSD (Acro)
2x RC breakout cable
1x vBat cable
1x buzzer cable
2x UART cables
4x Nylon Standoffs and nuts
1x Header Pin Assortment (Straight and 90 Degree)
Note: SKYLINE32+OSD hardware is compatible with NAZE32
firmware, including cleanflight, baseflight. Below are the links to the source
SKYLINE32+OSD is loaded with baseflight and
Baseflight-Configurator GUI. This manual is a baseflight Setup Tuning Guide for
If you are using cleanflight firmware, please refer to the
below link to download and install cleanflight Configurator:
Note: with firmware and configuration based on “MultiWii”
software, the processor used is not Atmel AVR, and can not be compiled via
Arduino or other AVR tools.
Below is some information about STM32 development:
User Manual :